Activity Stream

Found one failure...it has a leak in the exhaust. ​Will fix that and then take a look

I found this which should be helpful. DTC P1133 or P1153

That is the ones I got

And to fill the other hole on the A-pillar pod here is the Voltmeter gauge I installed--> Just a moment...

Below is the gauge I went with. You could choose any 2 1/16" gauge for the pod. Don't get a mechanical gauge. You don't need to have an oil line...

Not sure which ones you got from Amazon, but if they are the Dorman ones they should be fine. I've had my alum. ones in for over 200K with no...

4 ok doesnt seem tooo bad lol what is the unit that replaces the actual sensor itself or is it like a kit with that gauge also do you...

I changed the upstream O2 sensor but got the code P1133 anyway. ​What could this be?? All the other codes are gone.

Not really. Just a single wire with a ring terminal crimped on at the sending unit then run up to the gauge. Then you tap into a power source for...

is it hard to wire into the system?

Now I will change the O2 sensor before the Kat. And I have no engine light.... Maybe this helps ...

That is a tricky code. If we ignore that and just focus on fuel efficiency, your MAF sensor may stand a cleaning.

answer on this site for the code: Headers even with no leak will cause that code often. Something to do with more flow and the O2 sensor has trouble...

Got no codes until today...one was there: P1133 must take a look what this is

Yes thanks Jeepers I think this would be the solution the original coils. If my coils are broken I will order the original from rockauto. Can paint...

This --> Plus this--> Means I never have to worry about that ****ty oil sending unit leaking again. The oil gauge sending unit that...

not sure what "Autometer Sport Comp electric sending unit/gauge in my A-pillar pod" is but the sensor is not leaking bad so its fine for now still...

You might want to check your plugs to see if you can determine if one is not firing well. I know you will not want to hear it but, having gone...

Now I have only one question: The car has such high fuel consumption. Why? Before it was down on 10l/100km And now at 16,5l/100km. ​Whats that? ...

Do not drive it with the oil pressure sending unit leaking! That stupid thing has drained pans in the past and cost engines. I went through 3 and...

I'm currently rebuilding this guy. Aquacraft Supervee 27 Nitro.

could be my issue ima get to it tomorrow and tighten it up and looks like im also going to be changing that oilpressure sensor its finally failed...

@Kappa67, that is a great deal.

Thanks.. And here you can order the whole kit... CHEAP ABS Module Repair for Audi

The fluid could be soaking into the subframe mount and may have loosened up the mount a bit. I could maybe see that if the bolt is loose combined...