Activity Stream

Welcome, Ryan. Plenty of good info here. Good luck on the GTP!

FYI, if you have to replace the power steering pump itself, check to be sure that your rear knock sensor harness is not clipped to the bottom of the...

Thanks Scottydoggs....Ill be tearing into this POS today. Sorry if I seem a little whiney....it's just that I have been working on various vehichles...

this was a rack swap, so you dont want to drop the frame this much or you'll rip the steering shaft apart, or worse. them two lines are the ones you...

awlrighty then...It is sounding like this will be one of those jobs where colorful language is very present and plentiful... lol ...

theres a good chance its the return line thats just clamped on the pump leaking, they like to split a inch off the pump. you can just cut the line at...

that link on that post doesn't work anymore at least not for me i did search and i found this i think it might be the same thing as was googled...

'Thanks for the clarification. Now I put my other projects on hold and work on this piggy.....yaayyy.... lol

Not likely--> HUd color change?

No, the steering is not a hydro-boost setup. It's either just plain gears or maybe Magna-Steer (variable assist). If you have a single wire...

Ok thanks tomorrow I will take a look

It comes off of the harness for the ICM if I recall. It runs down under the coils/ICM and into the front of the engine. Cam is up top and then the...

Where is the harness for the cam? For the crankshaft sensor its ok

I would check the harness for the cam and crank position sensors. If the harness gets messed up it can cause those codes to pop up.

And now next thing: Sometimes car has misfires with ignition and after this the Computer goes wild. All is blinking I think this is due the codes...

Not sure on this, but maybe the BCM (body control module) is getting flakey?

Pics

Led?

seems pretty drastic for a misfire and no guarantee the misfire will disappear. a live scan while the engine is running to find out which cylinder...

Do the compression test and post the results. Is your GTP stock or did someone pulley down at some point? (install a smaller than stock diameter...

I'm pretty sure. It's quiet after an oil change, but that only lasts about half a day. '05 GTP (sorry, my signature didn't show.) I've...

At 131K that engine is just barely getting broken in. Are you sure it's a lifter tick and not an exhaust leak? Even at that, the lifters in these...

Yes saw it...thanks Thats why the indicator light is off now: The control module turns OFF the malfunction indicator lamp (MIL) after 3...

You check the fuses under the hood and on the inside panel? Just asking in case something easy was overlooked. If this car came with any kind of...