Thread: ZZP stage II I/C install

Im going to install the I/C tomorow.

Did modified gaskets. Now, any suggestions installing them?
This will be my first time and I want to do it right!

Any pics???

take your time and make sure you seal everything correctly the first time. plumb the lines nicely so they dont rub, ANYWHERE.

Don't use ZZP gaskets... they are named Garleaks for a reason. Get a couple rolls of gasket material and make your own if you are going to do it. I like Permatex 26B on both sides of it. Never had a leak yet.

Well, my first install. At least everything aling and went good. I used modified stock gaskets with little rtv. But surrounded all the areas completely, hope when.i fire it up doesnt leak! If it does. Ill use rtv only, btw where can I find these rolls you talk about?

I just picked up a couple rols at advanced auto. I got the rubber ones. They also have cork and paper, but I believe rubber it the best for this.

Also Bill I couldnt find permatex 26b anywhere? would the grey permatex work?

Oh ok thanks! and the rubber gasket material is the right stuff?