|
|
12-23-2010
I am in the process of putting this l67 together and im running into one more problem. I cant seem to get the fuel injectors to seal in the cylinder head. They dont seem to be going in all the way like they are getting hung up. I am using vasenline to try to convince them to go in..no luck any help would be great TIA
12-23-2010
Lube them up and then tap on the fuel rail with a rubber mallet.
12-23-2010
X2 I always just smeared alittle oil on them and tapped them in. If you over oil you will get some smoke out the exhaust from it burning the oil.
http://www.streetfire.net/video/2001...ynp_208097.htm
12-23-2010
I'm finally getting to do the LIM over Christmas, so I might run into this prob. Good to know these little tidbits for those of us who aren't experienced. Thanks.
12-23-2010
What a fun Christmas present for you! I did mine a couple weekends ago, not too bad.Originally Posted by GtpKo
Couple things that helped me out a lot...
1. Box of q-tips
2. Several rolls of paper towels
3. Extra vacuum hose rubber thingies they plug into
4. Made sure I had every part i needed before i started!
5. Camera for reference
6. Laptop
7. Tape and marker
Have a good time, stay warm!
12-23-2010
Just seat them in the rail then bolt it down.
If your rail isn't bent then they should seal no problem.
12-24-2010
I always lube them with oil, get them seated, bolt it down and go.
12-29-2010
I just dabbed a bit of oil on, went smoov. Gentle tap-tap to make sure they're in, no leaks
Oh ya, make sure the hole is very clean so the o-ring can seal well.
| « Previous Thread | Next Thread » |
| Bookmarks |
Bookmarks |
