|
|
03-07-2010
I need to replace the coolant temperature sensor on my 2000 GTP and was wondering if there is a way to get it off without removing the exhaust pipe next to it. It's sandwiched in there pretty good. I can get the 19mm deep socket on there, but I have no room to actually work it with the ratchet.
Thanks,
Steve
03-07-2010
Use a wrench.
03-07-2010
The wrench is either knocking into the pipe, or the engine block. I don't have any ratcheting wrenches, so I may need to get one to take care of it, if that's the only other way.
Thanks
03-07-2010
Never had to change one. Try a 12pt box end wrench.
03-03-2011
Were you able to get it off with the ratchet wrench? I'm trying to change the mother****** right now and quite frankly, I'm about to stick a piece of dynamite in the gas tank
03-03-2011
use a swivel socket or just take the crossover off its just 4 bolts
02-18-2013
It took me 2 hours to do with a wrench, biggest pain in the a**
02-18-2013
I have ratcheting wrenches. It's quicker. Still a pain.
Now..if we were not talking W body and that stupid dogbone wasn't in the way. You'd have enough room to do it in minutes.
07-12-2013
We're can I buy the pigtail for the coolent temp sensor?
07-13-2013
If you're looking for just the plug then RockAuto has it for $17... More Information for ACDELCO PT1623
If you need that plus some wire then a junkyard would be my first stop.
| « Previous Thread | Next Thread » |
| Tags for this Thread |
| Bookmarks |
Bookmarks |
