|
|
01-25-2010
Hey guys- I did a little looking around about this, and found some threads, still not sure. The gauge lights up just no reading. Does the MAP sensor feed this gauge or is it the vacuum line off the by pass valve? If it is the valve; where is the bypass valve located?
Btw got the coupler kit put in and a new SC belt and tensioner works great. Just trying to fine tune a few things...Thanks everybody!
Last edited by COEBAM; 01-25-2010 at 11:24 AM.
01-25-2010
I installed a plastic vacuum line T to tie into the vac line at the MAP sensor. Should read in the negatives on idle.
01-25-2010
depends what kind you got. did you get an digital or analog gauge?
01-25-2010
It's just the stock gauge located in the info center.
01-25-2010
that is read through the PCM, so id say you have a vacuum leak or your BBV is done for.
01-25-2010
Found a vacuum leak under super charger at the little tee. Thanks everyone!
01-29-2010
go ahead and replace crappy looking lines. i had several that were unnoticed for a while.
| « Previous Thread | Next Thread » |
| Tags for this Thread |
| Bookmarks |
Bookmarks |
