I need to replace the CPS for the phantom no start issue soon. Any tips on a puller to get/ where to get the one that works for this application? (on supercharged GTP)
|
|
08-14-2009
I need to replace the CPS for the phantom no start issue soon. Any tips on a puller to get/ where to get the one that works for this application? (on supercharged GTP)
Last edited by PCweber; 08-14-2009 at 01:52 PM.
08-14-2009
get one from autozone or something, but youll have to use different size bolts/washers to make it work. im not sure of the thread, but its a fine thread 1/4" bolts about 3" length.
when you get the crank bolt out, toss a stubby (short) 3/8" extension in the hole it came out of to protect the threads from the puller.
08-14-2009
OK thanks. I was in autozone a week ago and pickup up the sensor and they said they did not have a vib. dampner puller? I will try them again.
08-14-2009
found it. Called AZ and asked for manager. He knew exactly what I needed. Said it was a loaner tool you pay for and bring back and get 100% of your money back if it is all there. Here is the link to the AZ part #. AutoZone.com | Harmonic Balancer Puller
Also a link to another tool place with exact same part # and pic. OEM Industrial 27019 - Harmonic Balancer Puller Set
thanks all.
08-14-2009
Thats the standard tool, but you need different bolts, none included will work on this motor. You need these bolts:
https://www.zzperformance.com/grand_...=339&catid=111
08-14-2009
thats lame how they dont even tell you what bolts they are. i used 1/4" x 3" fine thread with some washers. still have it in my tool box for when i want to pull it again.
08-14-2009
i just use there three jawed puller. never had a problem before using one and if u strip the threads..oh well...you aint paying for it.
| « Previous Thread | Next Thread » |
| Tags for this Thread |
| Bookmarks |
Bookmarks |
