Where does this bolt go

**Scottydoggs** · 01-24-2019

nice find there, 2 dollar part i bet.

**Mrkt** · 01-25-2019

Nice I wouldn't mind a led there but the hyperflashing is what makes me not doing it. I'll be going to the junk so I don't have to solder anything

**Scottydoggs** · 01-25-2019

check that link ford posted, looks like its a twist out, only its very small. take old one out, take it to the parts store match up a new one.

**Mrkt** · 01-25-2019

Well I just went and got the new cluster. I didn't have the twist out part for it, and they said it was special order also

**Mrkt** · 01-25-2019

How long will I have to drive for to reset my intake air temperature sensor?

**Scottydoggs** · 01-25-2019

dont think theres a re set for that,

im readyness covers, the cat, o2 sensor, misfires, evap and egr.

if your still getting a code fo rit, check its wires for damage or try cleaning it, or replace it. they do get dirty and or go bad.

**Mrkt** · 01-25-2019

Okay how would I go about cleaning it?

**Scottydoggs** · 01-25-2019

wipe it off with some brake cleaner, it pulls out the intake tube.

**Mrkt** · 01-25-2019

Alright I tired that, I'm at the inspection place now to see if it's still popping up

**Mrkt** · 01-25-2019

It failed again because of the sensor, could me having a cone on the rubber vs the box have anything to do with it?

**Scottydoggs** · 01-25-2019

pop a new sensor in it, its likely bad. they are cheap, like 10 bucks.

**Mrkt** · 01-25-2019

I got a new sensor in, now when I took it up there it's not showing readyness, I drove it 110 miles and the evap and oxygen heater are the only ones not showing readyness

**Scottydoggs** · 01-25-2019

fill the tank drive some more. evap takes the longest the o2 can take a while too. needs a few drive cycles.

**Mrkt** · 01-25-2019

Okay I can definitely do that, the car is getting 4 mpg more then it did before so that's a plus. I'll drive it another 10 Miles tonight then another 40 tomorrow hopefully it will be good then

**Scottydoggs** · 01-25-2019

evap needs to see the gas level drop, or used, how ever you like to look at it. why i said fill the tank up. seen evap take more then a few days to become ready.

the o2 heater, if it dont become ready, it will set a code for the heater circuit. same for the evap. dont clear codes tho, or your restarting all over.