So I have just installed new injectors and fuel rail on my 01 gtp now nomatter what it will not start before it ran fine everything is hooked up ive checked twice
|
|
03-02-2018
So I have just installed new injectors and fuel rail on my 01 gtp now nomatter what it will not start before it ran fine everything is hooked up ive checked twice
03-02-2018
the fpr on the new rail might not be good.
03-02-2018
is everything oem or aftermarket?
03-02-2018
Everythings oemOriginally Posted by SgtMarshal
03-02-2018
Alright ill check
03-02-2018
you checked for fuel at the rail yet?
03-02-2018
Yea there's fuel to it how do I check the fpr
03-02-2018
if you got fuel it should at least try to start. if the vac line off it has gas in it, or smells of gas the fpr is bad.
what are these new injectors? stock replacements?
check for spark yet?
side note, the injector harness can have a bad spot that you aggravated by taking the plugs off. so you can look for a break, or also test the power at the plug, test light works, or you can take a marker light out the head light and push it in the injector plug. you turn the key to run and the bulb should flash a few times, or the test light will flash if its got power. it only flashes a few times then you have to re cycle the key, its the prime for the engine to start. if it dont flash at all you got no power to them.
03-02-2018
That maybe it because it wants to start but won't I checked the vac line it was dry but it does really smell of gas after a few cranks so I'm guessing bad fpr? They are stock replacements and another question how do I get the fpr off all the vids on YouTube are for the N/A and not supercharged don't know if its different being on the opposite side of the rail
03-02-2018
Do you still have the old FPR off the old rail? Swap?
Sent from my iPhone using Tapatalk
03-02-2018
Connect the big plug in front if you left it unhooked.
03-02-2018
Thankfully yes ill probably end up putting it on the new one once I find out how to take it off lol
03-02-2018
Most are a circlip. Get the clip out.. wiggle..wiggle...wiggle and it's out. Lube the o-ring before you put into the new one
03-02-2018
Alright thankyou
03-02-2018
I kinda doubt it's an fpr though
03-03-2018
If you step on the gas while starting with a bad FPR sometimes it will start.
Sent from my iPhone using Tapatalk
03-03-2018
Yea that's what I was trying I think I'm not getting a good seal on one injector I can spin it
Last edited by jetfighterv; 03-03-2018 at 12:54 PM.
03-03-2018
Yea its still not starting the one injector looked like there was a leak but there's no gas smell to it but when I'm trying to start it inside smells like gas
03-03-2018
what's the pressure at the rail key on engine off?
03-03-2018
What or where is that
Last edited by jetfighterv; 03-03-2018 at 01:58 PM.
| « Previous Thread | Next Thread » |
| Tags for this Thread |
| Bookmarks |
Bookmarks |
