Thread: 1990 GP 3.1 Hesitation and dies under acceleration

Results 1 to 5 of 5
  1. #1 1990 GP 3.1 Hesitation and dies under acceleration 
    SE Level Member jtmon's Avatar
    Join Date
    Nov 2009
    Location
    Alabama
    Posts
    4
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    I have a 1990 GP 3.1 and it has had a hesitation when I start to accelerate for a while now but it started something new last week. Now when I accelerate the engine dies. It will start back up most of the time but will die again if I try to accelerate hard. I have changed the ECM, MAP sensor, air temp sensor, fuel filter and fuel pump.
    Reply With Quote  
     

  2. #2 Re: 1990 GP 3.1 Hesitation and dies under acceleration 
    SE Level Member jtmon's Avatar
    Join Date
    Nov 2009
    Location
    Alabama
    Posts
    4
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    Well it's been over a month and I thought that someone here might have some insite to this problem.
    Reply With Quote  
     

  3. #3 Re: 1990 GP 3.1 Hesitation and dies under acceleration 
    Donating Users Ibwrong's Avatar
    Join Date
    Dec 2007
    Location
    Oklahoma City
    Posts
    943
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    Still got a cat? Sounds like a clogged cat? Is your check engine light on?
    2000 GTP - Project
    2000 Mustang GT
    2006 Charger
    Reply With Quote  
     

  4. #4 Re: 1990 GP 3.1 Hesitation and dies under acceleration 
    SE Level Member jtmon's Avatar
    Join Date
    Nov 2009
    Location
    Alabama
    Posts
    4
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    No Cat and no check engine light.
    Thanks for the reply.
    Reply With Quote  
     

  5. #5 Re: 1990 GP 3.1 Hesitation and dies under acceleration (Repaired) 
    SE Level Member jtmon's Avatar
    Join Date
    Nov 2009
    Location
    Alabama
    Posts
    4
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    OK guys I have finally fixed my problem and I wanted everyone to know what it was. After a lot of troubleshooting I discovered that when my engine was at operating temperature, 2 of my fuel injectors were loading down the control circuit and causing the car to die like someone turned off the ignition. When the engine died I removed the upper plenum and measured the resistance on all of the injectors, most measured around 11.6 ohms but I had 2 that measured a lot lower. One was 8.5 ohms and the lowest was 3.5 ohms. When the car cooled off the resistance improved allowing the car to run. So I replaced the injectors with another set I had and now it runs like new.
    Reply With Quote  
     

Similar Threads

  1. 1990 Grand Prix Prothane bushings....
    By nissanboy86 in forum Brakes/Suspension/Chassis
    Replies: 0
    Last Post: 09-19-2009, 11:21 PM
  2. Engine Hesitation
    By Blowntato in forum 3.8L V6 Naturally Aspirated (L36)(L26)
    Replies: 3
    Last Post: 07-28-2009, 06:52 AM
  3. hesitation problems
    By idahosox in forum 3.1L V6 (LHO/LG8)
    Replies: 4
    Last Post: 05-19-2008, 12:59 PM
Tags for this Thread

View Tag Cloud

Bookmarks
Bookmarks
Posting Permissions
  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •