|
|
09-14-2008
I have a 2000 Grand Prix GT 3.8 (no SC) and 144,000 miles The transmission was replaced under warranty at 65,000 miles by a GM Dealer and that same Dealer replaced the PCS at 115,000 miles under warranty as a result of rough shifts. A couple months ago I started experiencing rough shifts again between 1st and 2nd gears and I'm hearing a whine when I shift into drive or reverse only, the sound is not present when in park or neutral. The db of the whine is greater as I accellerate.
09-14-2008
First off, welcome to the forum. Happy to have you here. You're going to want to move this to the 3.8L V6 Naturaly Aspirated (L36)(L26) or Tech Section. You'll get more response for this topic.
09-14-2008
welcome.
09-14-2008
Actually, you'll be better off moving this subject to the 4T65E/4T65EHD section.Originally Posted by Starick58
Located here- 4 speed Automatic (4T65E) (4T65E-HD)
Also, welcome to the site.
And have you tried checking you transmission fluid? Is it low, and whats the quality of it?
09-14-2008
Welcome to the community.
Moved to the correct section.
09-14-2008
My bad. I totally overlooked it being a tranny problem and focused on it being a n/a motor. Good catch.Actually, you'll be better off moving this subject to the 4T65E/4T65EHD section.
Located here- 4 speed Automatic (4T65E) (4T65E-HD)
Also, welcome to the site.
And have you tried checking you transmission fluid? Is it low, and whats the quality of it?
09-14-2008
transmission filter maybe need to b replaced?
Originally Posted by SuperSport
09-14-2008
Welcome!!!
09-14-2008
If the pcs is acting up again or your trans is just worn to the point where the shifts become too lazy for the pcm's liking then it will throw code P1811 which is for max adapt shifts and when this is present the pcm commands max line pressure. If you shut the car off and start it back up and the noise goes away until the rough shifts start again then you may be looking at a bad pcs again or as mentioned above the trans is getting worn. The pcm monitors shift timing in milliseconds and if it falls outside of a given range then the code will set but will only be present often during the condition but should store in the pcm memory. When max line pressure is present you will hear a whining noise because the pump is working harder. To rule out a few things try this...... Put the shifter in drive when you hear this noise and if the noise is present with the car NOT moving then hold your left foot on the brake pedal and give the car some throttle to "load" the engine and work against the torque converter. Dont give it a lot of throttle just enough to rev the engine up to around 2K or so. Is the noise present sitting still in D or while revving it sitting still in D? The only thing that can make noise if the car is not moving and the shifter is in D or R for that matter is the pump or the torque converter itself. It should be safe to rule out the engine since you say it makes no noise in P or N range.
09-15-2008
If the P1811 code is present the correct way to fix the trans is a rebuild with the shift inprover kit. I went through this with my 02 gt about a month ago.
| « Previous Thread | Next Thread » |
| Tags for this Thread |
| Bookmarks |
Bookmarks |
