Thread: 9C1 Tranny Help

Results 1 to 10 of 10
  1. #1 9C1 Tranny Help 
    SE Level Member
    Join Date
    Aug 2008
    Location
    Whitby Ontario
    Posts
    30
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    Hey all,

    Impala's acting up, 3 days ago, i go to start the car, back the car out of the driveway, put it in drive, and nothing. engine revs, rpms jump, no motion. no nothing, had to drive in reverse around the block just so i could put it in the driveway. the car has 138,000km on it (85 749 for imperial people) any ideas? i have 3rd gear but that it, been riding a bike 5 km to work and school. I could really use some help!!!!


    Thank and much appreciated for help

    Marcel
    Reply With Quote  
     

  2. #2 Re: 9C1 Tranny Help 
    Transmission Expert Trannyman95's Avatar
    Join Date
    Dec 2007
    Location
    Fort Wayne, IN
    Posts
    1,858
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    Does it move forward if you pull the shifter in manual 1?
    Reply With Quote  
     

  3. #3 Re: 9C1 Tranny Help 
    SE Level Member
    Join Date
    Aug 2008
    Location
    Whitby Ontario
    Posts
    30
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    The car does move foward in 1, but with alot of slippage. it will not move if selector is in 3 or d.
    Reply With Quote  
     

  4. #4 Re: 9C1 Tranny Help 
    Donating Users justwhisen's Avatar
    Join Date
    Jul 2008
    Location
    Poteau Oklahoma
    Posts
    1,185
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    fluid- smell burnt, really dark, right level? check engine light?
    98 chevy truck
    83 Olds cutlass
    86 Olds cutlass
    06 se gold
    Reply With Quote  
     

  5. #5 Re: 9C1 Tranny Help 
    SE Level Member
    Join Date
    Aug 2008
    Location
    Whitby Ontario
    Posts
    30
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    fluid was pretty dark, no burn smell, check engine light on. Ran the codes, it was for passlock (due to alarm system). took it out for a drive around the block today. reverse was fine. slippage in drive and 3 and 2. put it in low, it INCHED foward till about 20 kph then less slippage to about 60 kph, after that, car changes gear, everythings normal. ??????
    Last edited by cobraz; 08-25-2008 at 09:05 AM.
    Reply With Quote  
     

  6. #6 Re: 9C1 Tranny Help 
    SE Level Member
    Join Date
    Aug 2008
    Location
    Whitby Ontario
    Posts
    30
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    why would first slip so much/?? i thought the tourque convertor or somthing like that?
    Last edited by cobraz; 08-25-2008 at 09:33 AM.
    Reply With Quote  
     

  7. #7 Re: 9C1 Tranny Help 
    Transmission Expert Trannyman95's Avatar
    Join Date
    Dec 2007
    Location
    Fort Wayne, IN
    Posts
    1,858
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    Manual 1 range produces much higher pressure, as well as manual 2, for engine braking reasons to give a stronger clamping force on the clutches and also to hold a manual 1-2 coast band for engine braking when going down a steep grade. There is a large combination of things that can cause your problem but you likely have a forward band on its way out and your manual 1-2 band is probably not far behind it if it is slipping that bad in manual 1 range from a stop. If the forward band is badly burnt or the apply lug as cracked it doesnt have the clamping force it needs to hold the drum it rides on which gives you no take off and lots of slippage. Once the vehicle shifts into 2nd gear this component isnt required to do its job like in 1st gear so you dont notice the problem. If your car drives fine from 2nd-4th gear this is likely what you have going on. That is not to say you dont have pressure problems or valve body problems but is what commonly happens when the car does not want to move in 1st and is acting how yours is acting. Also something very common is a bad or severly worn out input clutch piston inner sealing surface. 9 out of 10 transmissions have one that is worn and often when this happens the car wont want to move unless you rev it up a bit and then it will bang into gear and work fine until the car cools down. Any way you slice it you need some internal repair or a rebuild.
    Reply With Quote  
     

  8. #8 Re: 9C1 Tranny Help 
    SE Level Member
    Join Date
    Aug 2008
    Location
    Whitby Ontario
    Posts
    30
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    how hard is to get one of your transmissions to canada? i heard you have amazing transmissions...
    Reply With Quote  
     

  9. #9 Re: 9C1 Tranny Help 
    Transmission Expert Trannyman95's Avatar
    Join Date
    Dec 2007
    Location
    Fort Wayne, IN
    Posts
    1,858
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    I believe I can ship to Canada and the last quote I got was in the $400 ballpark. Not sure how far you are from the Detroit bridge but I could possibly help out on delivery as Detroit is only about 2.5-3 hours from here and would save you a lot of money and shipping time. I wont cross over the border so that would be up to you if interested.
    Reply With Quote  
     

  10. #10 Re: 9C1 Tranny Help 
    SE Level Member
    Join Date
    Aug 2008
    Location
    Whitby Ontario
    Posts
    30
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    i will pm you
    Reply With Quote  
     

Similar Threads

  1. 01 tranny in a 97
    By merked in forum 1997-2007 4 speed Automatic (4T65E) (4T65E-HD)
    Replies: 4
    Last Post: 08-28-2008, 03:55 PM
  2. 9C1 Tranny Help
    By cobraz in forum 3.8L V6 Naturally Aspirated (L36)(L26)
    Replies: 1
    Last Post: 08-22-2008, 08:51 PM
  3. 3rd Tranny!
    By offroadfury6 in forum Pre-1996 4 speed Automatic (4T60E)(4T60E-HD)
    Replies: 6
    Last Post: 08-21-2008, 12:02 PM
  4. Tranny???
    By Darkcelle in forum 1997-2007 4 speed Automatic (4T65E) (4T65E-HD)
    Replies: 5
    Last Post: 06-06-2008, 10:36 AM
  5. Tranny Man
    By 19SE92 in forum 1984-early 1990's 4 Speed Automatic (440T4)(4T60)
    Replies: 5
    Last Post: 02-15-2008, 11:38 PM
Tags for this Thread

View Tag Cloud

Bookmarks
Bookmarks
Posting Permissions
  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •