Good evening everyone. I am hoping someone can help. I recently changed my flex plate by dropping the transmission. I put it back together and it started nicely but now it has a loud clunk in the transmission. I feel it on the housing about 6 inches in on the housing. This is a nw noise. Fluid is full, I replaced the mounts while I had the cradle down, and I double checked the cradle bolts and mount bolts. Everything seems installed properly. I removed the half-shaft and reinstalled in because I thought it was not seated properly but it was. I am at a loss on this one. I am not sure why it's clunking. Both O2 sensors are throwing codes too but I think that's a sensor I forgot to plug back in. Any thoughts or ideas?
I appreciate your insights.
