Thread: EGR Inlet Tube Question

OK...I have my Speed Daddy headers installed. Everything worked out with the exception of the EGR inlet tube. It's bolted to the rear header EGR port, and I'm trying to get the bolt out.

What size is that bolt???

It's very hard to get in there with the crossover in. I don't want to remove it. Any tips for getting at this thing? A very short wrench perhaps?

I used a collapsible ratchet.. I believe its a 10mm if im not mistaken.. I also removed all my EGR crap and blocked everything off with block off plates.

I've see the bolt as both a 10mm and 13mm.

Whew...just got it out.

It was 10mm. I bought a 10mm flexible ratcheting wrench just for this bolt, but man, it made it so much easier!! It only took a few minutes. The right tool makes all the difference.

I'm going to take this wrench back and buy a whole set. These things are awesome.